Viking Range DFFB530 Guide d'installation télécharger pdf (Page 28)

Adjust and reposition bezel

as necessary. Tighten all screws securely.

Replace spill tray in lower part of bezel.

Align cube switch with sliding lever and firmly push

until sliding lever is flush with bezel.

For a left hinge door, cut 5/8” x 2-3/4” in lower left corner.

Note: Steps show panel upside down and notched for left

hinge application. Mirror dimensions for right hinge door.

Position upper mounting support over holes

underneath top section of bezel.

Ice and Water Dispenser Bezel Installation (if required) Ice and Water Dispenser Bezel Installation (if required cont.)

Push firmly into cavity until lower screw holes

align with mounting holes on cavity.

Install two screws in lower part of bezel

but DO NOT tighten all the way.

Install custom wood panels per product’s

installation instructions.

Locate opening in door and position bezel.

Note: Graphics on bezel will be on top end, tilt slightly

forward to allow water tube clearance.

Install Door Trim Insert

Use the roll of trim insert located in the drawer inside

the unit to apply to the door trim.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Pas de commentaire

Viking Range DFFB530 Guide d'installation Page 28